BMW 5 Series E39

since 1996-2001 release

Repair and operation of the car



BMW E39
+ Introduction
+ Maintenance instruction
+ Current leaving and service
+ Engine
+ Cooling systems, heating
+ Power supply system and release
+ Engine electric equipment
+ Manual transmission
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
- Suspension bracket and steering
   + Forward suspension bracket
   + Back suspension bracket
   - Steering
      Security measures during the work with a safety cushion
      Removal and installation of a steering wheel
      Removal and installation of the top facing of a steering column
      Removal and installation of a tip of steering draft
      Removal and installation of steering draft
      Fastening of a hydraulic pump
      Removal of air and filling of a hydraulic system of the power steering with liquid
      Check and adjustment of angles of installation of wheels
+ Body
+ Onboard electric equipment
+ Schemes of electric equipment
+ System of onboard diagnostics





Removal and installation of a tip of steering draft

 REMOVAL

1. Mark with paint the provision of a wheel concerning a nave. Thanks to it the balanced wheel can be established in former situation. Weaken bolts of fastening of a wheel on the car standing on the earth. Lift and install the car on supports and remove a wheel.
2. Turn off a lock-nut of fastening of a tip of steering draft, address the Section Removal and installation of a beam of a forward suspension bracket.

3. Turn off a nut of fastening of the spherical hinge at an inclined support.

4. Disassemble the sharovy hinge by means of a standard stripper, for example, of HAZET 779-1.

5. Turn off a tip of steering draft. At the same time keep steering draft a wrench from a provorachivaniye.

At an otvorachivaniye count speed. It will facilitate adjustment later. Pay attention to existence of the right and left carving.


 INSTALLATION

1. Screw a tip on steering draft. Speed equally earlier defined at a reversing.
2. Tighten a lock-nut of fastening of a tip the moment offered by Specifications.
3. Establish a tip in an inclined support. Fix it by the new self-stopped nut the moment offered by Specifications.
4. Establish and fix a forward wheel. Do not oil bolts or lubricant. Establish a wheel so that the markings put earlier at removal coincided. Lower the car on wheels. Tighten cross-wise bolts of fastening of a wheel the moment of 100 Nanometers.
5. Adjust a convergence, address the Section Check and adjustment of angles of installation of wheels.