BMW 5 Series E39

since 1996-2001 release

Repair and operation of the car


BMW E39
+ Introduction
+ Maintenance instruction
+ Current leaving and service
+ Engine
+ Cooling systems, heating
+ Power supply system and release
+ Engine electric equipment
+ Manual transmission
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
- Suspension bracket and steering
   - Forward suspension bracket
      Electronic control by rigidity of shock-absorbers (EDC)
      Removal and installation of a depreciation rack
      Dismantling of a depreciation rack / shock-absorber. Removal and installation of a screw spring
      Check and utilization of the shock-absorber
      Removal and installation of the bearing of a wheel
      Removal and installation of a beam of a forward suspension bracket
      Removal and installation of the lever of a cross suspension bracket
   + Back suspension bracket
   + Steering
+ Body
+ Onboard electric equipment
+ Schemes of electric equipment
+ System of onboard diagnostics



Removal and installation of the bearing of a wheel

If at turns, especially abrupt, from the region of an arrangement of a wheel external in relation to turn noise is heard, it indicates damage of the bearing of a wheel.

 REMOVAL

1. Remove a brake disk, address the Section Removal and installation of a brake disk / support of a forward brake.

  

2. Disconnect the pulse ABS (1) sensor. Address an accompanying illustration.
3. Remove a tip of steering draft from a rotary support, address the Section Removal and installation of a tip of steering draft.
4. Turn off the lower bolt of fastening 3/4. Remove a rotary fist (5) from a depreciation rack down. If necessary put marking of provision of a rack, address the Section Removal and installation of a depreciation rack.
5. Turn out 4 bolts (8) and remove the bearing (6) from a rotary fist.


 INSTALLATION

1. Clear the adjacent surfaces of the bearing of a wheel and a rotary fist, and also carving openings. Remove lubricant traces.
2. Install the bearing and fix it by the new self-stopped bolts the moment of 110 Nanometers.
3. Establish a rotary fist up, on a rack against the stop that previously put tags coincided.
4. Insert tightening a bolt and tighten with the self-stopped nut by effort 80 Nanometers.
5. Establish a head of steering draft on a rotary support, address the Section Removal and installation of a tip of steering draft.
6. Fix the pulse ABS sensor.
7. Establish a brake disk, address the Section Removal and installation of a brake disk / support of a forward brake.