BMW 5 Series E39

since 1996-2001 release

Repair and operation of the car



BMW E39
+ Introduction
+ Maintenance instruction
+ Current leaving and service
+ Engine
+ Cooling systems, heating
+ Power supply system and release
+ Engine electric equipment
+ Manual transmission
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
- Onboard electric equipment
   Diagnostics of malfunctions of onboard electric equipment - the general information
   Safety locks
   Fusible inserts
   Chain breakers (thermal relays)
   Relay
   Check of the relay
   Check of glow lamps
   Check of electric motors
   Check of electric switches
   Check of switches of lamps and electric motors
   Check of sensors
   Check of the electric motor of a screen wiper
   Check of a stoplight
   Check of a heater of back glass
   Removal and installation of the switch
   Removal and installation of the sensor of temperature
   Removal, installation and check of a sound signal
   Initialization of remote control of the uniform lock
   Adjustment of range of light of headlights
   Removal and installation of the electric motor of adjustment of range of light
   Replacement of safety locks
   Arrangement of safety locks
   Lighting devices
   Replacement of glow lamps
   Removal and installation of a headlight
   Adjustment of headlights
   Removal and installation of a back lamp
   Monitors
   Removal and installation of the block of the dashboard
   Replacement of lamps of the block of the dashboard
   Removal and installation of the switch of signals of a turn/screen wiper
   Removal and installation of the radio receiver
   Screen wiper
   Replacement of brushes of a screen wiper
   Removal, installation and adjustment snuffled windscreen washer
   Removal and installation of the drive of a screen wiper/cover
   Removal and installation of the electric motor of a screen wiper
   Check and replacement of the pump of windscreen washer
   Work with electric circuits
+ Schemes of electric equipment
+ System of onboard diagnostics




Replacement of glow lamps

It is recommended to have with itself in the car spare lamps. On sale the box with a set of spare lamps is offered. The list of lamps is provided in Specifications.

Switch off the switch of the corresponding lamp.

Headlights

Halogen lamps of driving, passing beam and fog light are under pressure. For protection of eyes use points, for protection of hands - gloves. Otherwise at damage of a lamp there is a danger of traumatizing.


 PERFORMANCE ORDER

1. Open a cowl.

 

2. Turn to the left against the stop the holder of a lamp of passing beam (1) and take out it.

3. Take out a lamp and replace it.
4. Establish the holder of a lamp of passing beam and turn it to the right against the stop.
5. Turn to the left against the stop the holder of a lamp of driving beam (2) and take out it
6. Rasstykuyte shtekerny connection.
7. Establish the new holder of a lamp with a lamp on a connector and record it.
8. Establish the holder of a lamp of driving beam and turn to the right against the stop.

Parking light

 PERFORMANCE ORDER

1. Turn to the left against the stop the holder of a lamp of parking light (3) and take out it.

2. Take out a lamp and replace it.

3. Insert into the case the holder of a lamp a big pad upward and turn to the right.

Turn signal forward

 PERFORMANCE ORDER

1. Squeeze the holder of a lamp for pads and take out him back.
2. Slightly press a lamp in the holder, turn on the left and take out.
3. Insert a new lamp, press it in the holder, turn to the right and record.
4. Press the holder of a lamp and record him.

Side repeater of turn

 PERFORMANCE ORDER

1. Press a lamp fingers at a back edge forward and take out.
2. Turn a lamp on the left, having slightly pressed and take out.
3. Slightly press on a new lamp, turn to the right and record it.

Fog light

Halogen lamps of driving, passing beam and fog light are under pressure. For protection of eyes use points, for protection of hands gloves. Otherwise at damage of a lamp there is a danger of traumatizing.


 PERFORMANCE ORDER

1. Remove a clip of a decorative lattice. For this purpose take out a pin (2), then a clip (1).

2. Disconnect a decorative lattice above and take out it.
3. Take out a cover near a fog light forward.

3. Turn out 2 two bolts of fastening and take aside a fog light.

4. Press a spring (1) from a reverse side in the direction of an arrow on an accompanying illustration.

5. Hook a cover (2) on the one hand and disconnect it with another.

6. Disconnect a spring clip (1) from the holder (2).

7. Uncover contacts and replace a lamp.
8. Fix a new lamp by a clip.
9. Check a condition of laying (3) in a cover, if necessary replace.
10. Insert a cover, press it and fix by a spring clip.
11. Insert a fog light and fix it by screws.
12. Fix a decorative lattice, press a clip and record it razzhimny pins.

Back lamp

 PERFORMANCE ORDER

1. Open a trunk lid.
2. Remove side facing.

3. Turn on 90 ° a clip (1) to the left and remove the holder of a lamp (2).

4. Slightly press a lamp in the holder, turn to the left and take out.

5. Insert a new lamp, press it a little in the holder, turn to the left and record.

6. Establish the holder of a lamp and turn a clip.

It is central the located stoplight

 PERFORMANCE ORDER

1. Open a trunk lid.
2. Remove the screw-driver a black plastic cover from the lower party of a hanger under headdresses.
3. Turn the holder of a lamp to the left and take out him.
4. Insert a new lamp, having pressed it a little in the holder, turn to the right and record.
5. Establish the holder of a lamp and fix, having turned to the right.
6. Fix a plastic cover from the lower side of the shelf under headdresses.

Lamp of illumination of registration plate

Power of a lamp is 5 W

 REPLACEMENT

1. Insert the screw-driver into a cut and press to the right, as shown an arrow; the lamp will leave fastening.

2. Remove a lamp and replace a lamp

Plafonds

Forward plafond

Main lamp (10 W), lamps of individual lighting (10 W)

 PERFORMANCE ORDER

1. Main lamp. Squeeze out a plafond, having hooked it sideways the screw-driver, and remove glass then take a lamp from contact holders.
2. Lamp of individual lighting. Take out a lamp, having slightly pressed on it and having turned to the left

Back plafond

Main lamp (10 W), lamp of individual lighting (5 W)

 PERFORMANCE ORDER

1. Squeeze out a plafond, having hooked it the screw-driver, having inserted into dredging from above
2. Main lamp. Having wrung out a uvula on a reflector, replace a lamp
3. Lamp of individual lighting. Take out a lamp, having slightly pressed on it and having turned to the left

Niche lighting lamps for legs

Power of lamps is 5 W

 PERFORMANCE ORDER

1. Remove lamp glass, having hooked it sideways the screw-driver
2. Replace a lamp

Lamp of illumination of a ware box

Power of a lamp is 5 W

 PERFORMANCE ORDER

1. Squeeze out a lamp, having hooked it the screw-driver inserted into dredging
2. Remove a reflector
3. Replace a lamp

Lamps of illumination of a luggage carrier

Lamp under the shelf behind back seats: 10 W, halogen
Lamp in a trunk lid: 10 W

 PERFORMANCE ORDER

1. Squeeze out a lamp, having hooked it the screw-driver inserted into dredging
2. Remove a reflector
3. Replace a lamp