BMW 5 Series E39

since 1996-2001 release

Repair and operation of the car



BMW E39
+ Introduction
+ Maintenance instruction
+ Current leaving and service
+ Engine
+ Cooling systems, heating
+ Power supply system and release
+ Engine electric equipment
+ Manual transmission
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
- Onboard electric equipment
   Diagnostics of malfunctions of onboard electric equipment - the general information
   Safety locks
   Fusible inserts
   Chain breakers (thermal relays)
   Relay
   Check of the relay
   Check of glow lamps
   Check of electric motors
   Check of electric switches
   Check of switches of lamps and electric motors
   Check of sensors
   Check of the electric motor of a screen wiper
   Check of a stoplight
   Check of a heater of back glass
   Removal and installation of the switch
   Removal and installation of the sensor of temperature
   Removal, installation and check of a sound signal
   Initialization of remote control of the uniform lock
   Adjustment of range of light of headlights
   Removal and installation of the electric motor of adjustment of range of light
   Replacement of safety locks
   Arrangement of safety locks
   Lighting devices
   Replacement of glow lamps
   Removal and installation of a headlight
   Adjustment of headlights
   Removal and installation of a back lamp
   Monitors
   Removal and installation of the block of the dashboard
   Replacement of lamps of the block of the dashboard
   Removal and installation of the switch of signals of a turn/screen wiper
   Removal and installation of the radio receiver
   Screen wiper
   Replacement of brushes of a screen wiper
   Removal, installation and adjustment snuffled windscreen washer
   Removal and installation of the drive of a screen wiper/cover
   Removal and installation of the electric motor of a screen wiper
   Check and replacement of the pump of windscreen washer
   Work with electric circuits
+ Schemes of electric equipment
+ System of onboard diagnostics





Removal, installation and adjustment snuffled windscreen washer

REMOVAL

1. Open a cowl.

 

2. Remove the lower part of facing of a cowl and cast away it. For this purpose turn out plastic screws (1) from a clip (2) and take out the screw-driver a clip.

3. Rasstykuyte shtekerny connection (1).

4. Disconnect a hose of supply of liquid to a nozzle (2).
5. Press a stopper and insert a jet (3) through an opening in a cowl.


 INSTALLATION

1. Press a nozzle into an opening of a cowl and record it.
2. Put on a liquid supply hose
3. Rasstykuyte shtekerny connection.
4. Lower a cowl. Press a clip and screw plastic screws.


 ADJUSTMENT

1. Mark a felt-tip pen on a point windshield, shown on an accompanying illustration, according to the sizes specified below, and include windscreen washer. Streams have to hit the corresponding nail. Otherwise nozzles need to be adjusted.
2. The sizes for adjustment of streams of windscreen washers.
A1 = 226
A2 = 540
B1 = 530
B2 = 506
C1 = 460
C2 = 450
D1 = 210
D2 = 505

3. The directions of streams snuffled can be adjusted by means of a wire or a needle. HUNDRED use the special HAZET 4850-1 tool to this purpose. The tool consists of a telescopic core with a needle on the end. The direction of a nozzle, than, for example, a needle allows to adjust the put-forward core more precisely.