BMW 5 Series E39

since 1996-2001 release

Repair and operation of the car



BMW E39
+ Introduction
+ Maintenance instruction
+ Current leaving and service
+ Engine
+ Cooling systems, heating
+ Power supply system and release
+ Engine electric equipment
+ Manual transmission
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
- Onboard electric equipment
   Diagnostics of malfunctions of onboard electric equipment - the general information
   Safety locks
   Fusible inserts
   Chain breakers (thermal relays)
   Relay
   Check of the relay
   Check of glow lamps
   Check of electric motors
   Check of electric switches
   Check of switches of lamps and electric motors
   Check of sensors
   Check of the electric motor of a screen wiper
   Check of a stoplight
   Check of a heater of back glass
   Removal and installation of the switch
   Removal and installation of the sensor of temperature
   Removal, installation and check of a sound signal
   Initialization of remote control of the uniform lock
   Adjustment of range of light of headlights
   Removal and installation of the electric motor of adjustment of range of light
   Replacement of safety locks
   Arrangement of safety locks
   Lighting devices
   Replacement of glow lamps
   Removal and installation of a headlight
   Adjustment of headlights
   Removal and installation of a back lamp
   Monitors
   Removal and installation of the block of the dashboard
   Replacement of lamps of the block of the dashboard
   Removal and installation of the switch of signals of a turn/screen wiper
   Removal and installation of the radio receiver
   Screen wiper
   Replacement of brushes of a screen wiper
   Removal, installation and adjustment snuffled windscreen washer
   Removal and installation of the drive of a screen wiper/cover
   Removal and installation of the electric motor of a screen wiper
   Check and replacement of the pump of windscreen washer
   Work with electric circuits
+ Schemes of electric equipment
+ System of onboard diagnostics




Removal and installation of the electric motor of a screen wiper

REMOVAL

1. Remove the screen wiper drive.

2. Disconnect a crank (4) from an axis, having turned off a nut (5).
3. Turn out three bolts of fastening (6) of the electric motor and remove it from the console.


 INSTALLATION

1. Expose the electric motor before installation in position of the parking. For this purpose join shtekerny connection and start the electric motor. Then switch off it the switch of a screen wiper and let's stop in extreme situation. Rasstykuyte shtekerny connection.
2. Fix the electric motor on the console.
3. Establish a crank so that it was on one line with drafts. Fix a nut by the moment of 25 Nanometers.
4. Install the screen wiper drive.