Replacement of brushes of a screen wiper
Replacement of brushes of a screen wiper needs to be made at poor quality of purification of glass. At the same time it is possible to replace or only brushes, or complete with brush holders. If only the brush is replaced, it is necessary to check whether has deformations the brush holder.
|
| 1. Raise a brush and you keep it in such situation. |
2. Displace a clip (1) in the direction of an arrow and remove a brush towards a windshield. |
|
3. Squeeze passatizham both steel tires from the closed party of a brush and take out sideways from the top bracket. Take out rubber together with tires from the rest of brackets. |
|
4. Insert a new brush without tire into the lower brackets. |
|
5. Enter both tires into the first flute of a brush so that grooves of tires showed towards rubber and record in flute pads.
6. Squeeze both steel tires and a brush of a passatizhama and insert into the top bracket so that bracket pads on both sides entered grooves (shooter) of a brush.
7. Insert a brush via the lever and displace a lock clip back.
8. Cast away the lever back. You watch that the brush adjoined to a windshield everywhere. |
|
|