BMW 5 Series E39

since 1996-2001 release

Repair and operation of the car



BMW E39
+ Introduction
+ Maintenance instruction
+ Current leaving and service
+ Engine
+ Cooling systems, heating
+ Power supply system and release
+ Engine electric equipment
+ Manual transmission
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
- Onboard electric equipment
   Diagnostics of malfunctions of onboard electric equipment - the general information
   Safety locks
   Fusible inserts
   Chain breakers (thermal relays)
   Relay
   Check of the relay
   Check of glow lamps
   Check of electric motors
   Check of electric switches
   Check of switches of lamps and electric motors
   Check of sensors
   Check of the electric motor of a screen wiper
   Check of a stoplight
   Check of a heater of back glass
   Removal and installation of the switch
   Removal and installation of the sensor of temperature
   Removal, installation and check of a sound signal
   Initialization of remote control of the uniform lock
   Adjustment of range of light of headlights
   Removal and installation of the electric motor of adjustment of range of light
   Replacement of safety locks
   Arrangement of safety locks
   Lighting devices
   Replacement of glow lamps
   Removal and installation of a headlight
   Adjustment of headlights
   Removal and installation of a back lamp
   Monitors
   Removal and installation of the block of the dashboard
   Replacement of lamps of the block of the dashboard
   Removal and installation of the switch of signals of a turn/screen wiper
   Removal and installation of the radio receiver
   Screen wiper
   Replacement of brushes of a screen wiper
   Removal, installation and adjustment snuffled windscreen washer
   Removal and installation of the drive of a screen wiper/cover
   Removal and installation of the electric motor of a screen wiper
   Check and replacement of the pump of windscreen washer
   Work with electric circuits
+ Schemes of electric equipment
+ System of onboard diagnostics




Removal and installation of the switch

 PERFORMANCE ORDER

1. Disconnect a weight cable from the rechargeable battery. The battery is in a luggage carrier behind the right side facing.

At a detachment of the battery the memories given in electronic blocks, for example, memories of malfunctions of the engine are erased. Address recommendations of the Section Removal and installation of the rechargeable battery.

Example: Switch of the alarm system

2. Uncover on the top of the gear shifting lever.
3. Wring out the damping insert aside.
4. Through an opening in the central console squeeze out from below the switch.
5. Rasstykuyte shtekerny connection.

Example:
Switch of heating of a seat.

6. Remove the control unit of the heater/conditioner, address the Section Removal and installation of the control unit of a heater or the conditioner. Through an opening in the central console squeeze out from below the switch.

7. Rasstykuyte shtekerny connection. For this purpose fingers press a stopper. Address an accompanying illustration.

Example:
Light switch.

8. Remove the handle (1) from light switch.

9. Remove a dashboard block frame, address the Section Removal and installation of the block of the dashboard.
10. Turn off a nut (4) from a switch axis.
11. Remove a diaphragm (2).
12. Rasstykuyte shtekerny connection.
13. Squeeze out the switch of light (3) from a frame back.
14. Installation of the switch is made in the return sequence.
15. Attach a weight cable to the rechargeable battery. Establish hours. Program stations of the radio receiver.