2. Insert the screw-driver into a cut near an axis of the regulator of loudness and turn on 90 °. Take out the screw-driver and together with it the control panel to the left and take away them to the right.
If the screw-driver directly does not enter a groove, put it, turn on 90 ° and, thus, having displaced a clamp to the right, at the same time open a groove. Turn the screw-driver further and insert into a groove.
3. Rasstykuyte shtekerny connection. For this purpose reject a clip aside.
4. Turn two screws of fastening (3) radio receivers with an internal hexagon to the left so that it could be taken out easily.
5. Rasstykuyte multi-polar shtekerny connection (1) by the screw-driver. Disconnect a cable of weight (2). Disconnect an antenna wire (3).
INSTALLATION
1. Join multi-polar shtekerny connection and an antenna wire from a reverse side of the radio receiver. Fix by the screw a weight cable. 2. Insert the radio receiver into a dashboard opening. 3. Fix screws with an internal hexagon. 4. Establish multi-polar shtekerny connection at the radio receiver control panel. Cast away a clip and record it. 5. Insert the control panel into a car dashboard opening so that it was fixed. 6. Install the loudness regulator button.