BMW 5 Series E39

since 1996-2001 release

Repair and operation of the car



BMW E39
+ Introduction
+ Maintenance instruction
+ Current leaving and service
+ Engine
+ Cooling systems, heating
+ Power supply system and release
+ Engine electric equipment
+ Manual transmission
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
- Onboard electric equipment
   Diagnostics of malfunctions of onboard electric equipment - the general information
   Safety locks
   Fusible inserts
   Chain breakers (thermal relays)
   Relay
   Check of the relay
   Check of glow lamps
   Check of electric motors
   Check of electric switches
   Check of switches of lamps and electric motors
   Check of sensors
   Check of the electric motor of a screen wiper
   Check of a stoplight
   Check of a heater of back glass
   Removal and installation of the switch
   Removal and installation of the sensor of temperature
   Removal, installation and check of a sound signal
   Initialization of remote control of the uniform lock
   Adjustment of range of light of headlights
   Removal and installation of the electric motor of adjustment of range of light
   Replacement of safety locks
   Arrangement of safety locks
   Lighting devices
   Replacement of glow lamps
   Removal and installation of a headlight
   Adjustment of headlights
   Removal and installation of a back lamp
   Monitors
   Removal and installation of the block of the dashboard
   Replacement of lamps of the block of the dashboard
   Removal and installation of the switch of signals of a turn/screen wiper
   Removal and installation of the radio receiver
   Screen wiper
   Replacement of brushes of a screen wiper
   Removal, installation and adjustment snuffled windscreen washer
   Removal and installation of the drive of a screen wiper/cover
   Removal and installation of the electric motor of a screen wiper
   Check and replacement of the pump of windscreen washer
   Work with electric circuits
+ Schemes of electric equipment
+ System of onboard diagnostics




Removal and installation of the switch of signals of a turn / screen wiper

Switches of signals of a turn / screen wiper are removed equally. The description is provided on the example of the switch of signals of turn.


 REMOVAL

1. Lower a steering column completely down and put forward.

2. Turn out three screws of fastening of the lower facing of a steering column.

3. Press on the top facing of a steering column on both sides inside in the place shown on an accompanying illustration and pull the lower facing down.

4. Turn out the screw (the shooter on an accompanying illustration) and remove the top facing of a steering column.

5. Squeeze brackets above and below and take out the switch.

6. Squeeze brackets and a rasstykuyta shtekerny connection.


 INSTALLATION

1. Join shtekerny connection and record it.
2. Insert into place the switch and fix it.
3. Fix the lower facing of a steering column by three screws.
4. If it is necessary, replace a nut of fastening of the top facing of a steering column.

5. Establish the top part and record it. At the same time enter a hook (1) into reception openings (2).

6. Press the top part of a sidewall of a steering wheel down and record sideways in the lower part.
7. Fix by screws the top part.
8. Establish a steering column in normal situation.