BMW 5 Series E39

since 1996-2001 release

Repair and operation of the car



BMW E39
+ Introduction
+ Maintenance instruction
+ Current leaving and service
+ Engine
+ Cooling systems, heating
+ Power supply system and release
+ Engine electric equipment
+ Manual transmission
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
+ Body
- Onboard electric equipment
   Diagnostics of malfunctions of onboard electric equipment - the general information
   Safety locks
   Fusible inserts
   Chain breakers (thermal relays)
   Relay
   Check of the relay
   Check of glow lamps
   Check of electric motors
   Check of electric switches
   Check of switches of lamps and electric motors
   Check of sensors
   Check of the electric motor of a screen wiper
   Check of a stoplight
   Check of a heater of back glass
   Removal and installation of the switch
   Removal and installation of the sensor of temperature
   Removal, installation and check of a sound signal
   Initialization of remote control of the uniform lock
   Adjustment of range of light of headlights
   Removal and installation of the electric motor of adjustment of range of light
   Replacement of safety locks
   Arrangement of safety locks
   Lighting devices
   Replacement of glow lamps
   Removal and installation of a headlight
   Adjustment of headlights
   Removal and installation of a back lamp
   Monitors
   Removal and installation of the block of the dashboard
   Replacement of lamps of the block of the dashboard
   Removal and installation of the switch of signals of a turn/screen wiper
   Removal and installation of the radio receiver
   Screen wiper
   Replacement of brushes of a screen wiper
   Removal, installation and adjustment snuffled windscreen washer
   Removal and installation of the drive of a screen wiper/cover
   Removal and installation of the electric motor of a screen wiper
   Check and replacement of the pump of windscreen washer
   Work with electric circuits
+ Schemes of electric equipment
+ System of onboard diagnostics




Removal and installation of the block of the dashboard

 REMOVAL

1. Lower a steering column completely down and put forward.
2. Remove wooden peaks of a steering column at the left and on the right.

3. Uncover. For this purpose unscrew three screws of fastening from below.

4. Turn out three screws above and remove a frame. Rasstykuyte shtekerny connection of the switch of a fog light also hang up a frame cover. If it is necessary, a rasstykuyta shtekerny connection of the switch of passing beam. In this case light lights up and the light signaling device joins. That to exclude it, take out the corresponding safety lock.

Depending on execution the cover can be fixed by two screws above and below and is in addition recorded above.

5. Turn out two screws of fastening and cast away the dashboard block.

6. Rasstykuyte shtekerny connection also remove it. For this purpose open a clip and take away from a cable.


 INSTALLATION

1. Join shtekerny connection and record it a clip. You watch that the clip was reliably recorded.
2. Insert the dashboard block into an opening and fix by screws.
3. Join shtekerny connection of the switch of light.
4. Establish a cover and fix it by screws.
5. Establish into place wooden peaks.
6. Establish a steering column in normal situation.