Before removal of a mirror warm up the car to the room temperature (about +20 °C). At lower temperature clips can break.
REMOVAL
1. Cast away a mirror upward.
Usual mirror 2. Paste over edge of a mirror and edge of the case of a mirror with a tape for protection against damages. 3. Take out a mirror from below a wooden wedge. It can also be extended from below fingers.
Automatically no-glare mirror 4. Displace the small screw-driver a support (the shooter on an accompanying illustration) to the right. It allows to open a bayonetny lock and to carefully remove a mirror. 5. Rasstykuyte shtekerny connection of heating of a mirror and the blinding automatic equipment.
6. Remove a mirror.
INSTALLATION
1. Join shtekerny connection of heating of a mirror and the blinding automatic equipment.
2. Establish a mirror so that clips were under pads.
Usual mirror 3. Press a mirror directly under clips and record it. Enclose a rag not to leave fingerprints on a mirror.
Automatically no-glare mirror 4. Press a mirror. Enclose a rag not to leave fingerprints. Displace a support the small screw-driver to the left, so that it was vertical.