BMW 5 Series E39

since 1996-2001 release

Repair and operation of the car



BMW E39
+ Introduction
+ Maintenance instruction
+ Current leaving and service
+ Engine
+ Cooling systems, heating
+ Power supply system and release
+ Engine electric equipment
+ Manual transmission
+ Automatic transmission
+ Coupling and power shafts
+ Brake system
+ Suspension bracket and steering
- Body
   Care of a body
   Care of the finishing panels manufactured of vinyl
   Care of an upholstery and rugs of salon
   Repair of insignificant damages of body panels
   Repair of considerable damages of a body
   Body gaps
   Removal and installation of a front bumper
   Removal and installation of shock-absorbers of a front bumper
   Removal and installation of a rear bumper
   Removal and installation of the shock-absorber of a rear bumper
   Removal and installation of a forward wing
   Removal and installation of a cowl
   Adjustment of provision of a cowl
   Removal and installation of a trunk lid
   Adjustment of provision of a trunk lid
   Removal and installation of back facing of a luggage carrier
   Removal and installation of the lock of a cover of the luggage carrier/cylinder of the lock
   Removal and installation of a gas-filled emphasis of a cowl/trunk lid
   Replacement of a slip / company inscription
   Removal, installation and adjustment of a door
   Removal and installation of facing of a door
   Removal and installation of the door lock
   Removal and installation of the external handle of a door
   Removal and installation of the cylinder of the lock
   Removal and installation of the electric motor/microswitch of the uniform lock
   Removal, installation and adjustment of door glass
   Removal and installation of the power window
   Removal and installation of an external mirror
   Removal and installation of glass of a mirror
   Removal and installation of the case of an external mirror
   Removal and installation of an internal mirror
   Removal and installation of the central console
   Removal and installation of the electric motor of the movable panel of the hatch of a roof
   Removal and installation of a front seat
   Seat belt tension device
   Security measures at the handling of the belt tension device
   Protection of the device of a tension of a belt
   Removal and installation of a back seat
   Removal and installation of the shelf under a headdress
   Removal and installation of blinds of back glass
+ Onboard electric equipment
+ Schemes of electric equipment
+ System of onboard diagnostics




Removal and installation of the central console

 REMOVAL

1. Uncover the gear shifting lever.

2. Remove the switch of the alarm system and the uniform lock. For this purpose through an opening under the lever of gear shifting wring out foam isolation aside and squeeze out the switch from below. Rasstykuyte shtekerny connection.
3. Rasstykuyte shtekerny connection of the lighter through an opening under the gear shifting lever.
4. Remove the control unit of a heater or the conditioner, address the Section Removal and installation of the control unit of a heater or the conditioner.

The control unit has dense landing. Therefore at first remove the central console, and then squeeze out the control unit from a reverse side.

5. Squeeze out the switch under the control unit through an opening under the control unit. Rasstykuyte shtekerny connection.

6. Remove side rugs at the left and on the right. For this purpose turn out a bolt (1). Displace a side rug forward and disconnect it from clips.

7. Unscrew screws (2) and (3).

8. Uncover the parking brake from above of the console, incline it forward and disconnect from below.

9. Weaken the screw (4).
10. Turn out bolts (5) and (6), uncover.

11. Disconnect a side cover of the lever of the parking brake. For this purpose take a cover behind sideways aside of a seat of the driver and take out.

12. Press a back lattice of cooling (1) a little upward and the screw-driver sideways remove the holder of cans or a box (2) (an arrow on an accompanying illustration).

13. Displace a cooling lattice down and remove it.

14. Turn out two screws of fastening (7) and (8).

15. Shift a seat completely back and turn out in a back part at the left and on the right below two bolts of fastening, having uncovered the small screw-driver (11).

16. Wring out isolation of a casing of gear shifting aside and turn out the screw (9).

17. Turn out a bolt (10).

18. Raise behind the central console a little. Rasstykuyte under it shtekerny connection of a lamp of illumination of an ashtray. Previously mark the plug with a tape.
19. Establish both front seats, backs and translate the lever of gear shifting or the selector it is possible further back.

20. Raise behind the central console, pull back, towards a seat of the forward passenger and take out.


 INSTALLATION

1. Install the central console from a seat of the forward passenger.
2. Join shtekerny connection of the switch of the parking brake under the console.
3. Install the control unit of a heater or the conditioner, address the Section Removal and installation of the control unit of a heater or the conditioner.
4. Fix a gear shifting lever cover.